New brass thru-hull drain tubes were installed using a modified air-chisel/flaring tool as described by Tom Clark (http://www.whalercentral.com/articles...icle_id=42). I used o-rings and Boatlife Life-Caulk sealant to seal the ends of these. The remaining transom hardware (transducer and pitot tube) was also reinstalled using Boatlife Life-Caulk to seal the screw holes. The left side of the transom is picture here.

Click image for maximum view
Date: 07/04/19 - 2:05 PM
Added by: wlagarde
Dimensions: 640 x 480 pixels
Filesize: 118.5Kb
Comments: 0
Number of views: 2625