Before Posting, Please Read Our Posting Guidelines Below.
1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011 2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260 3. Include the length when necessary. Example: 16, 17, 18, 20, 22 4. Do not post your email address anywhere on this site as it is already in your user profile.
Rich,
My plan is to cut the floor down the center where I already have bad gelcoat and glass that I need to replace. Then dig out the foam as far out toward the sides as I can. I replace it with 2 part foam. Ii suspect when I get to that point, I will weigh the hull again, dig out as much foam as I can and reweight and see where I get too. I also plan to dig out some foam from the port side where a bad replacement rail was installed that left a huge hole and we foam.
I got a reply from Chuck Bennett around the location of the braces. They were not always in the same place so you have to find them by tapping on the floor.
))) Oy my acking back
