Before Posting, Please Read Our Posting Guidelines Below.
1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011 2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260 3. Include the length when necessary. Example: 16, 17, 18, 20, 22 4. Do not post your email address anywhere on this site as it is already in your user profile.
before I goop on the 4200, Should I cut the PVC "Flush", or leave them extended a little bit and seal with "Marine Tex" or "PC-11" around the hull where it meet's the drain tube ?
Any Thought's ?
On my Montauk, I extended them about an inch or 2. This way the water comes out past the hull and does not leave a stain running straight down the hull.
Sorry I didn't see this one earlier Matt. You have probably already gone about it since it is Sunday evening now. I would say just coat the hole with some epoxy resin and push the tube in. Check your mail about your PM.
