1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

Prop for 1987 18 Outrage
bonefish	#1  Posted on 03/28/24 - 2:55 PM
Member Posts: 2 Comments: 0 Joined: 01/23/07	Guys, repowering with a 2023 Mercury 115hp 4 stroke series (non command thrust). Anyone have suggestions on prop? Engine height when install? And last, if I rehub a viper 14 3/4 x 17 I had from an etec, would it be suitable for the new Merc?
Phil T	#2  Posted on 03/29/24 - 6:28 AM
Administrator Personal Page Personal Album Project Albums Posts: 6994 Comments: 6 Joined: 03/26/05	What is your typical load going to be? Rigging the engine and prop selection is critical given the power. Mount the engine 3 holes up, top bolt in the 4th hole down from the top. It is worth the expense of a new hub for the Viper. Try it. Should target a WOT speed of 37-38 running light and solo. I would also look at a 14.5 x 15 Enertia (not cheap) 1992 Outrage 17 I 2019 E-TEC 90, Viper 17 2+ 2018 Load Rite Elite 18280096VT
bonefish	#3  Posted on 03/29/24 - 1:52 PM
Member Posts: 2 Comments: 0 Joined: 01/23/07	Thank you Phil. I did get a new hub for the viper, will start with that prop an see how it goes. load will be light....2-3 people, probably 450-500 lbs.. gas variable. The engine height I appreciate.