1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

Conquest Plastic Seatback Removal
subpar	#1  Posted on 12/23/23 - 9:03 AM
Member Posts: 6 Comments: 0 Joined: 06/10/23	I want to have my seatback for the helm and passenger side reupholstered. Both have plastic seatbacks with a 3 tiered bolster setup. I cannot figure out how to remove the plastic seatbacks to remove the bolsters so I can take them to an upholstery shop. 2006 305 Conquest subpar attached the following image: [139.33Kb] Edited by subpar on 12/23/23 - 9:05 AM
subpar	#2  Posted on 12/23/23 - 9:06 AM
Member Posts: 6 Comments: 0 Joined: 06/10/23	Here's the seat front subpar attached the following image: [100.54Kb]
butchdavis	#3  Posted on 12/24/23 - 8:37 AM
Member Posts: 827 Comments: 0 Joined: 11/22/11	It looks like the seatback may be attached to the seat bottom from beneath the seat.
Phil T	#4  Posted on 12/28/23 - 10:37 AM
Administrator Personal Page Personal Album Project Albums Posts: 6991 Comments: 6 Joined: 03/26/05	To dovetail on Butch's advice ----- See Sheet 2 on this diagram set for removing the backrest. It is a PDF download from Whaler. https://www.bostonwhaler.com/content/...t-2006.pdf 1992 Outrage 17 I 2019 E-TEC 90, Viper 17 2+ 2018 Load Rite Elite 18280096VT
subpar	#5  Posted on 12/29/23 - 6:47 AM
Member Posts: 6 Comments: 0 Joined: 06/10/23	Thanks for the help, I'm guessing you and Butch meant the 2 screws holding the arms in place circled in the attached pic? I loosened them but they appear to not have anything to do with the attachment of the 3 upholstered bolsters. I think it's just the end support for the entire seat section. Upon further investigation (careful prying!) It looks like the plastic seat back is attached to another while plastic backing underneath that may be used to attach bolsters Anyway I took my pics to a good local marine upholsterer and he is going to come down to the dock and check it out next time he's in our area subpar attached the following image: [47.32Kb] Edited by subpar on 12/29/23 - 8:45 AM 2006 305 Conquest
Noleboy77	#6  Posted on 03/28/24 - 2:59 PM
Member Posts: 2 Comments: 0 Joined: 04/10/21	I have same issue on 2004 conquest. Please post the answer