Before Posting, Please Read Our Posting Guidelines Below.
1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011 2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260 3. Include the length when necessary. Example: 16, 17, 18, 20, 22 4. Do not post your email address anywhere on this site as it is already in your user profile.
Hi - We have a 1997 Boston Whaler 20' Outrage with a 2006 200 Evinrude Engine. Yesterday I took a look at the back bilge area and found the automatic bilge hose loose and not connected to anything. Can someone help in suggesting where the hose should go or be connected to?
bash7ty attached the following image:
[167.91Kb]
Edited by bash7ty on 09/21/21 - 3:11 AM
The spiral hose in the bottom left of the photo is from the bilge pump. which needs to be rotated so it is sitting on the floor of the bilge. The end of the hose should connect to a through hull fitting on the inside sidewall of the boat. Look on the outside of the boat, near the Whaler logo for a through hull fitting. It is not the floor drain, rather 4-5 inches above the waterline. That is the fitting, just attach the hose with stainless clamps to the inside of the fitting.
Edited by Phil T on 09/21/21 - 6:00 AM
1992 Outrage 17 I
2019 E-TEC 90, Viper 17 2+
2018 Load Rite Elite 18280096VT