Before Posting, Please Read Our Posting Guidelines Below.
1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011 2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260 3. Include the length when necessary. Example: 16, 17, 18, 20, 22 4. Do not post your email address anywhere on this site as it is already in your user profile.
I need to install the old norman pin. The screw broke off and I bought a new one from Twin Marine. Now I need to install it. Should I suse (great stuff) foam to fill the gap when I install it? or just screw it in and use life caulking?
Are you saying there is a gap between the Norman pin screw and the boat? In other words is the hole "wallowed-out". If so you probably need to fill the area with some epoxy or similar material then re-drill the hole to re-install. The entire Norman pin area was in bad shape on my 16' and had to be re-built. I used West System epoxy with colodial silica additive to thicken and toughen the mixture. Worked fine but re-driling the hole straight is a bit tricky; start with a long 1/8" drill.