Posted by kevin nolan on 04/06/06 - 5:29 PM
#17
The tube comes flared at one end. It's a 45 degree angle. I'm going to cut the flare off. How do you flare just one end if there is no flared end and you cut both sides at an angle? The flaring tool flares both end at the same time. Thanks again, you're a lot of help. I'm glad I found this site. Sunday is the day I retry this. I hope I do OK. I think I will. Thanks a lot.
Kevin
Edited by Tom W Clark on 04/06/06 - 5:39 PM