---

Grady, this pile is not being run through this boat, but will (hopefully) be removed sometime this coming week enmass, and my ETEC installed. The wiring i will be running unfortunately tomorrow night as it is raining and lightning outside as we speak, will be my just removed ETEC stuff.

To answer your question, I plan on running the engine wiring harness through first as it has the most to hang up, then the shifter and throttle cables together, then the hot wire, as the ground is already run. Then i'll run my hydro lines as they have the least of all to hang up on. None of it of course will i attach together except for just in the ends in case i ever need to pull one line or the other out. The other lines for my airator, pump and GPS fish finder etc are already in.

Where the fun will come in is when i install the Yamaha on Raggedy and reinstall that mess. Lots more stuff with a older motor. But i'll bet you when its done, it will look a ton better then that mess photo that started this whole thread off!! :D

I'll update with a photo when the job is done.

Duf B)