Posted by Phil T on 05/24/23 - 7:46 AM
#7
Patrick - You should check the mounting hole spacing you have on the transom.
I emailed you the measured drawing of the BIA standard pattern.
To mount the engine, I would start with the top bolt in the 3rd hole counting down from the top (assuming the top mounting hole is 1-7/8" (47.6 mm) down from the top of the transom.
When you raise or lower the engine it will affect WOT rpm's by 150 for each hole, plus or minus.
Edited by Phil T on 05/24/23 - 7:49 AM