Posted by Phil T on 08/31/21 - 8:20 AM
#4
For each screw hole -
Using painters tape, mask off area around hole (1-2" diameter).
Mix up the Locketite. With a disposable syringe (craft store or Amazon), or plastic putty knife, fill the hole just to the top, no more.
Cover the hole with a piece of 2" long piece of clear packing tape to get a smooth surface. If the epoxy spreads wider than the hole, remove tape, wipe off excess, reapply tape.
Let cure. Remove all tape.
For sealant I use Boat Life's Life Caulk. Never silicone.
Edited by Phil T on 08/31/21 - 8:22 AM