Thread subject: Whaler Central - Boston Whaler Boat Information and Photos :: Kicker motor placement on Montauk 17

Posted by Great Lakes on 08/13/21 - 8:38 AM
#1

Looking for some advice on kicker placement on a 1989 Montauk 17. The kicker is a 1988 Evinrude Excel 4 hp long shaft Yacht Twin that weighs approximately 37 lb. This will be mounted directly to the transom. I understand the starboard transom is the preferred location on this Montauk and my owner's manual states " All 17 foot models have wood molded into the upper starboard transom. Auxiliary engines can be clamped directly onto this area without the use of special pads".

I have seen other discussions (or photos) on this topic that would indicate port transom is acceptable too for placement and wood is molded on the raised portion of transom on both port and starboard. In my case I would prefer the port transom placement for two reasons 1) The kicker steering linkage I have will connect to the main engine steering rod best from the port side, and 2) the stern light stanchion is located on the starboard side and would need to be moved.

Would like some feedback on this. Thanks.

Edited by Great Lakes on 08/13/21 - 8:39 AM

Posted by Joe Kriz on 08/13/21 - 1:14 PM
#2

Whatever works best for your kicker and your application.
Here is one member that mounted on the Port side due to the cables etc. as you mentioned.
https://www.whalercentral.com/infusio...er_id=5953

Posted by Great Lakes on 08/14/21 - 2:42 PM
#3

Thanks Joe, appreciate the info.

- Tim

1989 Montauk 17'

Posted by Joe Kriz on 08/14/21 - 2:53 PM
#4

Sure Tim.

I also mounted a kicker on the Port side of my Outage 18' as it worked out best for me.

Also see the Dual controls for the motors on both the Montauk 17' above and my Outrage 18' below.
https://www.whalercentral.com/article...icle_id=48