Posted by ontario_outrage on 04/11/16 - 3:16 PM
#1
Hi all,
Working on a 2012 190 Outrage
I want to run electrical wires from the console to the port gunnel. Does anyone know if I can safely drill between the gas filler access area and the gunnel, or is there foam there?
Thanks!
Posted by ontario_outrage on 04/12/16 - 7:19 AM
#2
FWIW, I emailed the same question to BW, and here is their reply:
"Yes, you can drill a hole in this location, however, you might run into a little bit of foam depending on the exact area that you drill the hole. Not a big deal though. Just make sure to seal the hole at both ends."