Posted by jbgator22 on 09/21/15 - 10:15 AM
#1
The screws holding the compartment in place has came out on my 1999 Dauntless 18. I was just going to remove the current screws and replace with new ones. All of the hardware looks fine. Anyone else have to replace these? If so any advice?
Posted by gchuba on 09/21/15 - 9:51 PM
#2
I like using a two part epoxy with a syringe applicator into the hole with a small hardwood splinter. You can dry test the splinter for sizing before the epoxy. Too big and it throws off the original pilot hole. Sometimes two small ones.
Garris
Posted by jbgator22 on 09/30/15 - 5:46 AM
#3
Thanks gchuba, Going to give it a try this weekend!