Whaler Central - Boston Whaler Boat Information and Photos

Posted by janetwarner on 03/27/15 - 9:04 AM

I have a 1986 15' SS with a 70 hp Yamaha engine. I am trying to locate a pump with a float attached that will fit into the rather small sump area. The ones I have seen have large float shut off and won't fit.

Posted by Jay Fitz on 03/27/15 - 10:48 AM

I have the Rule-Mate 500 gph pump. It's an oval shape 4" x 5" in my 1978 Montauk, fits in the sump and allows the cover to be closed, no problem. Runs via a sensor, not a float.

Here's another thread to check out:

http://www.whalercentral.com/forum/vi...rowstart=0

Posted by wing15601 on 03/27/15 - 1:00 PM

On my 13 foot Whaler which I trailer I can just lean back from the helm and pull the plug and having taken water over the transom that's exactly what I've done. I use the type of plug with the screw in/out shaft to swell the rubber rather than the lever type. I have the diameter adjusted do it will easily pull out but not pop out on its own. My Montauk 17 stays in a slip so I have one of those Rule automatic pumps that makes a test every minute or two looking water. I have had that system for three years now and even leaving the boat for three weeks doesn't seem to effect the batteries ability to start the engine. Someone gave me a 500GPH Sahara pump with a built in float and I think it would fit but the Rule is so small I'm sticking with it. Only problem with bilge pumps on Whalers is you have to remember to leave them set to auto or if you have enough rain it could fill the boat to the gunnels.

Posted by Jay Fitz on 03/27/15 - 5:20 PM

wing15601 wrote: Only problem with bilge pumps on Whalers is you have to remember to leave them set to auto or if you have enough rain it could fill the boat to the gunnels.

The Rule only turns on when it senses water. Doesn't check for water every so often and potentially draining the battery and no worries about switching it on, it's always on.