---

How rare are 16 7 cohassets

---

The Boston Whaler 16 Cohasset I and II models (I with a captains chair; II with a Reverse Pilot Seat) were manufactured during the years 1972-1973 at the Rockland, MA., factory. The Cohasset was distinguished by its narrow pedestal console base with a "top heavy" upper console that had a low profile grap rail and centerline mounted helm. The Cohasset was designed as a solution to multiple owner complaints related to the lack of space between the 40 inch and 35 inch "Nauset" style mahogany consoles and the interior bulkheads on the Nauset, Sakonnet, and Eastport 16 models. The Cohasset console was the only Boston Whaler console not secured to the deck of the 16 hull with floor cleats or screws. Instead, the console pedestal had a base that was laminated to the deck in a square area around the forward rig tunnel opening. During the 1972-1973 period, Boston Whaler had three 16 hull forms that produced three hulls per day, or circa 15 hulls a week. Maybe 3 Cohasset models were produced per week, usually by special customer order, because Boston Whaler did not want to accumulate overstock of the Cohasset model. During its short manufacture life, Boston Whaler received owner reports of structural failure of the Cohasset console pedestal base. Apparently, the console was prone to physical separation at the base where it was laminated to the deck, when the hull was operated in heavy seas, e.g., with the pilot holding onto the console rail and steering wheel. After almost two years of production, the Cohasset was phased out as the Montauk 16 model came into production. The Cohasset console was also installed on the Boston Whaler 21 Outrage, circa 1971. A Cohasset 16 in original good-very good condition could be considered a collectable model for it unique configuration. There are, however, other Boston Whaler 16 models that were manufactured in few numbers than the Cohasset, namely the Tashmoo.

---

thanks weatherly, i got a 1972 cohasset i got the pic on my personal page didnt know how to get it on thread.

(corrected abbreviated year to full 4 digit year)

---

Frank, I don't see your personal page.

---

Hey, wanted to add something to the laminated note by Weatherly. The pedestal base in my 1972 Cohasset is wood blocks. The console screws into the wood blocks with horizontal screws. The only play mine had (bought in 2008) was some loosening in the horizontal screws which tightened up with some wood putty and good SS screws. What I need to check at my next opportunity is if the wood base is only glued/laminated to the deck or has vertical screws into wood beneath the deck.

The wood locating diagram shows that there is plywood (wood P) underneath where the console support is for the Cohasset. The diagram mentions P is available after hull #3A5411. My hull # is after that.

---

My Cohasset II never had the console laminated to the deck. It was attached via horizontal screws as mentioned. I wrote to Chuck Bennet at Boston Whaler and he related that according to their records approximately 600 Cohassets were made (No mention of the breakdown between I and II).