Thread subject: Whaler Central - Boston Whaler Boat Information and Photos :: Looking to replace/remove my transom mounted ball scupper

Posted by VA Whaler on 06/18/14 - 12:04 PM
#16

Garris, sorry for the delay in responding. The fuel line travels from the fuel/water separator down to the small hatchway that covers the deck's bilge pump. I have not traced its route from there to the onboard fuel tank but I will take a closer look this weekend. In my testing I'm using an external fuel tank with its own fuel line, primer bulb, etc.

I'm going to slightly hijack my own thread for a minute and ask you something about the thru hull drain tubes on your 22' Revenge. I have two that do not extend all the way through the hull and terminate with the standard flare. There is a flared end on the "topside" and they extend to just about the edge of the gelcoat and stop. They are then covered by the clamshell covers. The two drains include the fish/bait tank and the starboard main deck bilge. The other thru-hull drains have flared ends on both ends. Are your drains set up in a similar way or do all of your drains have flared ends?

Thanks!

John

Edited by VA Whaler on 06/18/14 - 12:07 PM