Posted by Clyde in TS on 04/23/14 - 9:19 AM
#1
any special trick to removing the rub rail on a 1985 15 foot Whaler so I can replace the wiring to the bow light?
This site is a wonderful resource to a new owner of an old boat! I have not found another Whaler owner in the Greers Ferry Lake area.
Thanks in advance
Posted by Phil T on 04/23/14 - 9:31 AM
#2
If you have the two or three piece, just remove the black insert. You don't need to remove the receiver track.
Tinned marine speaker wire is a recommended choice of wire.
Posted by Clyde in TS on 04/23/14 - 3:24 PM
#4
Your reply to my previous post was why I asked about the removal of the rub rail. Since my boat is a 1985 15 foot custom, I was checking to see if there was a best way to remove the rub rail and not damage it - rather than dive into it, screw it up and then have to buy a new rub rail.
I thank you for your patience and assistance!
cg