Posted by JPB on 04/19/14 - 5:35 PM
#14
I got the blind holes filled this week and replaced two of the drain tubes on the transom. I was ready to drill the green holes however the engine looked a little high to me so I took some pictures for some feedback. The last 4 pictures on my personal page shows the engine mounted all the way up.
Picture one: the bracket is about 1.5 inches off the transom.
Picture two: a board laying across the cavitation plate with engine trimmed all the way down.
picture three: motor is trimmed up slightly
picture four: board is in same position as 3 and engine is trimmed all the way down.
My question is will this mounting position work?
Thanks.
Joey