---

It arrived yesterday - and it is a universal fit with a 30" arm and a plastic float. No directions came with it - it looks like you bend the arm to shape then crimp the arm so the float stays in place. There are two small flat washers, one on each side of the float so a small crimp will keep the float in place. It's very well made and comes with four new mount screws and a new rubber flange gasket. It looks like the correct one, it will be hard to tell until I adjust the float arm correctly. I'm hoping to get it installed today...

FYI: It worked out to about $88 with shipping.

Here's some pix:

http://i1133.photobucket.com/albums/m...G_0901.jpg

http://i1133.photobucket.com/albums/m...G_0900.jpg

http://i1133.photobucket.com/albums/m...G_0899.jpg