Posted by cjay on 09/17/10 - 2:33 PM
#1
Hello i am new. I just bought a 196X 13. I am planning my restore and have a question. There is flaking on the non skid. How should I resolve? I can sand the non-skid away then use an algrip paint non skid, but would rather stay original. Please advise.
a link to the phone is below:
http://www.jaytammy.com/nonskid.jpg
[img]http://www.jaytammy.com/nonskid.jpg[/img]
Posted by cjay on 09/20/10 - 7:42 AM
#2
Did I not post enough information? Is the picture too hard to see?
Posted by Derwd24 on 09/20/10 - 8:40 AM
#3
Did you see this thread below? If you want to keep it factory, watch the video in post #4 and give a read to the article in post #8. Removing and recreating the non-skid from scratch may be your only option:
http://whalercentral.com/forum/viewth...;pid=68309
Posted by Jeff on 09/20/10 - 8:55 AM
#4
I would recommend sanding it all the nonskid off and back to the glass and then refinishing the floor with an Alwgrip roll on nonskid.