Posted by Northern Exposure on 08/26/10 - 6:58 AM
#1
1985 Montauk. What was the original disconnect for anchor light? The one I have has crimp on connectors and they are corroded and do not work even though 11.8 volts is showing. I want to put a new connector on and wondered what was original?
Posted by Joe Kriz on 08/26/10 - 10:29 AM
#2
Here's a tip for everyone that is looking for Part Photos and Information on our site.
On the front of our main page is an image you can click on to get information and a photo of a part you are looking for.
Click on the "OEM Part Photos Index" image and that will take you to all the part photos we have on our site.
We have these photos and information so people can quickly see what parts were original along with any parts that might have a replacement.
We have spent many hours taking part photos, collecting photos of parts, and collecting information about these parts.
Please spend some time browsing through the "OEM Part Photos Index" or the Part Photos link on the left sidebar to see what information is there.
Below is a photo of our Main Page with the link to the "OEM Part Photos Index" right in the center.
Click on that image to view more.
I hope this helps everyone see what we have to offer here in that section.
Posted by Northern Exposure on 08/26/10 - 11:12 AM
#3
Thanks Joe. I see a picture of the stern light with connector.
Posted by Paulsv on 08/26/10 - 9:10 PM
#5
I just bought a set of these at the shop at my marina. It was with the trailer hardware. I think I stii have the package. I'll check tomorrow for the manufacturer and part number.
Posted by Paulsv on 08/28/10 - 8:06 AM
#6
Here is a link to the connector:
http://www.marinepowerservice.com/BoatingStore/browse_detail3.cfm/productID/17779.cfm
Posted by Joe Kriz on 08/28/10 - 6:17 PM
#8
That Sierra connector is the same one we have listed in the info under the photo.