View Thread
Before Posting, Please Read Our Posting Guidelines Below.

1. Use the full 4 digit year for everything you are asking your question about. Example: 1962, 1988, 2000, 2011
2. Include the correct name of your Whaler model. Example: Montauk 17, Montauk 170, Outrage 26, Outrage 260
3. Include the length when necessary. Example: 16, 17, 18, 20, 22
4. Do not post your email address anywhere on this site as it is already in your user profile.

 Print Thread
2005 Nantucket 190 Bilge Sump Drain
Rising Tides
#1 Print Post
Posted on 05/25/17 - 1:27 PM
Member

Posts: 15
Comments: 0
Joined: 05/25/17

New to the Whaler, just purchased an 2005 outrage Nantucket 190. Boat will live on a slip. It has dual batteries. What is the preferred way of leaving the vessel. Should the Bilge Sump drain be plugged or unplugged and I need to leave the batteries turned on for the bilge to kick on if it rains? Thanks in advance for your help.

 
butchdavis
#2 Print Post
Posted on 05/26/17 - 5:33 AM
Member

Posts: 822
Comments: 0
Joined: 11/22/11

Drain plug in. To test your bilge pump reach into the bilge and lift the float switch if you can. Do this with the battery switch turned on and turned off.

If your bilge pump float switch is not manually operable use a hose to raise the water level in the bilge until the pump begins to run. Again, do this with the battery switch set to off and to on.

It would probably be a good idea to perform the flooding test regardless as it's useful to know if and how well your bilge pump operates.

If shore power is available at your slip consider installing an automatic battery charger to prevent your bilge becoming flooded if your batteries run out of usable power. Dead batteries are a primary cause of flooded or sunken boats in slips.


Butch
 
holy_crap
#3 Print Post
Posted on 05/26/17 - 10:02 AM
Member
Personal Page

Posts: 18
Comments: 0
Joined: 05/24/13

if on a lift I would just leave the plug out to be safe. If the boat stays in the water, then you need to make sure the plug is in and sealed, I believe the bilge pump is wired directly to the battery, so even with the battery switch in the off position the bilge pump should work, and if you leave the plug out it will drain your battery. The only way to know for sure is to test it as mentioned above.


Edited by holy_crap on 05/26/17 - 10:06 AM
 
Rising Tides
#4 Print Post
Posted on 05/26/17 - 4:26 PM
Member

Posts: 15
Comments: 0
Joined: 05/25/17

I appreciate both the replies, thanks for the advice.

 
Jump to Forum:
Bookmark and Share
Today's Date & Time
March 28, 2024 - 11:17 PM
Users Online
Welcome
93SL16MN
as the newest member

· Guests Online: 8
· Members Online: 0
· Total Members: 49,964
Login
Username

Password

Remember Me


Not a member yet?
Click here to register.

Forgotten your password?
Request a new one here.
Top 5 Models Posted
· Montauk 17 1,622
· Sport 13 1,354
· Outrage 18 549
· Nauset 16 396
· Sport 15 363

View all Models Here
Render time: 0.14 seconds Copyright WhalerCentral.com © 2003-2024 82,705,596 unique visits